Source File
mspanset.go
Belonging Package
runtime
// Copyright 2020 The Go Authors. All rights reserved.// Use of this source code is governed by a BSD-style// license that can be found in the LICENSE file.package runtimeimport ()// A spanSet is a set of *mspans.//// spanSet is safe for concurrent push and pop operations.type spanSet struct {// A spanSet is a two-level data structure consisting of a// growable spine that points to fixed-sized blocks. The spine// can be accessed without locks, but adding a block or// growing it requires taking the spine lock.//// Because each mspan covers at least 8K of heap and takes at// most 8 bytes in the spanSet, the growth of the spine is// quite limited.//// The spine and all blocks are allocated off-heap, which// allows this to be used in the memory manager and avoids the// need for write barriers on all of these. spanSetBlocks are// managed in a pool, though never freed back to the operating// system. We never release spine memory because there could be// concurrent lock-free access and we're likely to reuse it// anyway. (In principle, we could do this during STW.)spineLock mutexspine unsafe.Pointer // *[N]*spanSetBlock, accessed atomicallyspineLen uintptr // Spine array length, accessed atomicallyspineCap uintptr // Spine array cap, accessed under lock// index is the head and tail of the spanSet in a single field.// The head and the tail both represent an index into the logical// concatenation of all blocks, with the head always behind or// equal to the tail (indicating an empty set). This field is// always accessed atomically.//// The head and the tail are only 32 bits wide, which means we// can only support up to 2^32 pushes before a reset. If every// span in the heap were stored in this set, and each span were// the minimum size (1 runtime page, 8 KiB), then roughly the// smallest heap which would be unrepresentable is 32 TiB in size.index headTailIndex}const (spanSetBlockEntries = 512 // 4KB on 64-bitspanSetInitSpineCap = 256 // Enough for 1GB heap on 64-bit)type spanSetBlock struct {// Free spanSetBlocks are managed via a lock-free stack.lfnode// popped is the number of pop operations that have occurred on// this block. This number is used to help determine when a block// may be safely recycled.popped uint32// spans is the set of spans in this block.spans [spanSetBlockEntries]*mspan}// push adds span s to buffer b. push is safe to call concurrently// with other push and pop operations.func ( *spanSet) ( *mspan) {// Obtain our slot.:= uintptr(.index.incTail().tail() - 1), := /spanSetBlockEntries, %spanSetBlockEntries// Do we need to add a block?:= atomic.Loaduintptr(&.spineLen)var *spanSetBlock:if < {:= atomic.Loadp(unsafe.Pointer(&.spine)):= add(, sys.PtrSize*)= (*spanSetBlock)(atomic.Loadp())} else {// Add a new block to the spine, potentially growing// the spine.lock(&.spineLock)// spineLen cannot change until we release the lock,// but may have changed while we were waiting.= atomic.Loaduintptr(&.spineLen)if < {unlock(&.spineLock)goto}if == .spineCap {// Grow the spine.:= .spineCap * 2if == 0 {= spanSetInitSpineCap}:= persistentalloc(*sys.PtrSize, cpu.CacheLineSize, &memstats.gcMiscSys)if .spineCap != 0 {// Blocks are allocated off-heap, so// no write barriers.memmove(, .spine, .spineCap*sys.PtrSize)}// Spine is allocated off-heap, so no write barrier.atomic.StorepNoWB(unsafe.Pointer(&.spine), ).spineCap =// We can't immediately free the old spine// since a concurrent push with a lower index// could still be reading from it. We let it// leak because even a 1TB heap would waste// less than 2MB of memory on old spines. If// this is a problem, we could free old spines// during STW.}// Allocate a new block from the pool.= spanSetBlockPool.alloc()// Add it to the spine.:= add(.spine, sys.PtrSize*)// Blocks are allocated off-heap, so no write barrier.atomic.StorepNoWB(, unsafe.Pointer())atomic.Storeuintptr(&.spineLen, +1)unlock(&.spineLock)}// We have a block. Insert the span atomically, since there may be// concurrent readers via the block API.atomic.StorepNoWB(unsafe.Pointer(&.spans[]), unsafe.Pointer())}// pop removes and returns a span from buffer b, or nil if b is empty.// pop is safe to call concurrently with other pop and push operations.func ( *spanSet) () *mspan {var , uint32:for {:= .index.load(), = .split()if >= {// The buf is empty, as far as we can tell.return nil}// Check if the head position we want to claim is actually// backed by a block.:= atomic.Loaduintptr(&.spineLen)if <= uintptr()/spanSetBlockEntries {// We're racing with a spine growth and the allocation of// a new block (and maybe a new spine!), and trying to grab// the span at the index which is currently being pushed.// Instead of spinning, let's just notify the caller that// there's nothing currently here. Spinning on this is// almost definitely not worth it.return nil}// Try to claim the current head by CASing in an updated head.// This may fail transiently due to a push which modifies the// tail, so keep trying while the head isn't changing.:=for == {if .index.cas(, makeHeadTailIndex(+1, )) {break}= .index.load(), = .split()}// We failed to claim the spot we were after and the head changed,// meaning a popper got ahead of us. Try again from the top because// the buf may not be empty.}, := /spanSetBlockEntries, %spanSetBlockEntries// We may be reading a stale spine pointer, but because the length// grows monotonically and we've already verified it, we'll definitely// be reading from a valid block.:= atomic.Loadp(unsafe.Pointer(&.spine)):= add(, sys.PtrSize*uintptr())// Given that the spine length is correct, we know we will never// see a nil block here, since the length is always updated after// the block is set.:= (*spanSetBlock)(atomic.Loadp()):= (*mspan)(atomic.Loadp(unsafe.Pointer(&.spans[])))for == nil {// We raced with the span actually being set, but given that we// know a block for this span exists, the race window here is// extremely small. Try again.= (*mspan)(atomic.Loadp(unsafe.Pointer(&.spans[])))}// Clear the pointer. This isn't strictly necessary, but defensively// avoids accidentally re-using blocks which could lead to memory// corruption. This way, we'll get a nil pointer access instead.atomic.StorepNoWB(unsafe.Pointer(&.spans[]), nil)// Increase the popped count. If we are the last possible popper// in the block (note that bottom need not equal spanSetBlockEntries-1// due to races) then it's our resposibility to free the block.//// If we increment popped to spanSetBlockEntries, we can be sure that// we're the last popper for this block, and it's thus safe to free it.// Every other popper must have crossed this barrier (and thus finished// popping its corresponding mspan) by the time we get here. Because// we're the last popper, we also don't have to worry about concurrent// pushers (there can't be any). Note that we may not be the popper// which claimed the last slot in the block, we're just the last one// to finish popping.if atomic.Xadd(&.popped, 1) == spanSetBlockEntries {// Clear the block's pointer.atomic.StorepNoWB(, nil)// Return the block to the block pool.spanSetBlockPool.free()}return}// reset resets a spanSet which is empty. It will also clean up// any left over blocks.//// Throws if the buf is not empty.//// reset may not be called concurrently with any other operations// on the span set.func ( *spanSet) () {, := .index.load().split()if < {print("head = ", , ", tail = ", , "\n")throw("attempt to clear non-empty span set")}:= / spanSetBlockEntriesif uintptr() < .spineLen {// If the head catches up to the tail and the set is empty,// we may not clean up the block containing the head and tail// since it may be pushed into again. In order to avoid leaking// memory since we're going to reset the head and tail, clean// up such a block now, if it exists.:= (**spanSetBlock)(add(.spine, sys.PtrSize*uintptr())):= *if != nil {// Sanity check the popped value.if .popped == 0 {// popped should never be zero because that means we have// pushed at least one value but not yet popped if this// block pointer is not nil.throw("span set block with unpopped elements found in reset")}if .popped == spanSetBlockEntries {// popped should also never be equal to spanSetBlockEntries// because the last popper should have made the block pointer// in this slot nil.throw("fully empty unfreed span set block found in reset")}// Clear the pointer to the block.atomic.StorepNoWB(unsafe.Pointer(), nil)// Return the block to the block pool.spanSetBlockPool.free()}}.index.reset()atomic.Storeuintptr(&.spineLen, 0)}// spanSetBlockPool is a global pool of spanSetBlocks.var spanSetBlockPool spanSetBlockAlloc// spanSetBlockAlloc represents a concurrent pool of spanSetBlocks.type spanSetBlockAlloc struct {stack lfstack}// alloc tries to grab a spanSetBlock out of the pool, and if it fails// persistentallocs a new one and returns it.func ( *spanSetBlockAlloc) () *spanSetBlock {if := (*spanSetBlock)(.stack.pop()); != nil {return}return (*spanSetBlock)(persistentalloc(unsafe.Sizeof(spanSetBlock{}), cpu.CacheLineSize, &memstats.gcMiscSys))}// free returns a spanSetBlock back to the pool.func ( *spanSetBlockAlloc) ( *spanSetBlock) {atomic.Store(&.popped, 0).stack.push(&.lfnode)}// haidTailIndex represents a combined 32-bit head and 32-bit tail// of a queue into a single 64-bit value.type headTailIndex uint64// makeHeadTailIndex creates a headTailIndex value from a separate// head and tail.func (, uint32) headTailIndex {return headTailIndex(uint64()<<32 | uint64())}// head returns the head of a headTailIndex value.func ( headTailIndex) () uint32 {return uint32( >> 32)}// tail returns the tail of a headTailIndex value.func ( headTailIndex) () uint32 {return uint32()}// split splits the headTailIndex value into its parts.func ( headTailIndex) () ( uint32, uint32) {return .head(), .tail()}// load atomically reads a headTailIndex value.func ( *headTailIndex) () headTailIndex {return headTailIndex(atomic.Load64((*uint64)()))}// cas atomically compares-and-swaps a headTailIndex value.func ( *headTailIndex) (, headTailIndex) bool {return atomic.Cas64((*uint64)(), uint64(), uint64())}// incHead atomically increments the head of a headTailIndex.func ( *headTailIndex) () headTailIndex {return headTailIndex(atomic.Xadd64((*uint64)(), (1 << 32)))}// decHead atomically decrements the head of a headTailIndex.func ( *headTailIndex) () headTailIndex {return headTailIndex(atomic.Xadd64((*uint64)(), -(1 << 32)))}// incTail atomically increments the tail of a headTailIndex.func ( *headTailIndex) () headTailIndex {:= headTailIndex(atomic.Xadd64((*uint64)(), +1))// Check for overflow.if .tail() == 0 {print("runtime: head = ", .head(), ", tail = ", .tail(), "\n")throw("headTailIndex overflow")}return}// reset clears the headTailIndex to (0, 0).func ( *headTailIndex) () {atomic.Store64((*uint64)(), 0)}